Time Setting - Salora Elite 2 Manuel D'utilisation

GENERAL FUNCTIONS
Switching the Ultra Bass System on and off
This function boosts the bass frequencies. You can follow the below procedure to switch on and off the
UBS when the sound setting is CLASSIC, POP, JAZZ or ROCK.
1. Press and hold the DSC/UBS button to switch the Ultra Bass System on and off.
Notes:
Listening with UBS at high volume may have distortion. Recommend to use at low volume.
Listening with headphones
1. Connect the headphones to the Headphone socket (Ø3.5mm).
– This switches off the loudspeakers.
Warning:
Excessive sound pressure from earphones and headphones can cause hearing loss.

TIME SETTING

In standby mode, when the time and day flash on the display, this indicates that they need to be set.
Time setting may only be performed in standby mode.
1. Press the Time button to select the hour format between 12HR and 24HR.
2. Press and hold down the Time button until the hour digits flash on the display.
3. Set the hour by using the Rewind or Forward button, and press the Time button to confirm.
The minute digits flash.
4. Use the Rewind or Forward button to set the minute, and then press the Time button to confirm.
The day of week flashes.
5. Set the day of week by using the Rewind or Forward button, and press the Time button to
confirm.
"CT ON" flashes on the display.
6. Use the Rewind or Forward button to set the RDS time synchronisation, press the Time button to
confirm and finish the time setting.
Notes:
You must reset the time after a power failure or when the mains plug is pulled out.
Some RDS stations transmit an RDS time signal. If the selected RDS programme transmits this time
information, the time will be automatically updated. This may take a few minutes.
elite2_ib.indd 9
All manuals and user guides at all-guides.com
8
1/3/2011 17:48:06