Tuner Mode - Salora Elite 2 Manuel D'utilisation

TUNER MODE

Connecting the antenna
1. Plug the wire antenna supplied or the outdoor antenna cable into the FM Antenna socket.
Fully extend the wire antenna for FM reception.
2. Insert the wires of the MW frame antenna supplied into the MW Antenna connector with the same
colour.
Adjust the position of the antenna to have better reception.
Notes:
The wires must be inserted into the connectors matched with the same colour; otherwise, no MW fre-
quency signal can be received.
Selecting the Tuner input source
1. Switch on the device by pressing the On/Off button
2. Press the Function button to select the input source, FM Tuner or MW Tuner.
Automatic station search
A radio station search starts automatically when you connect the device to the mains for the first time.
The device searches for up to 40 stations (shared by FM and MW) with the best reception and stores
them as preset stations.
You can also start a new search to delete all the existing preset stations and replace them with new sta-
tions at the same time.
1. Start the automatic station search in tuner mode by pressing and holding the Prog. button.
After the search has finished, you will hear the station stored in preset position 1.
Notes:
The automatic station search can be interrupted by briefly pressing the Stop button.
Automatic station search (one station)
You can search for a station without replacing the existing preset memory.
1. Press the Function button to select the frequency band, FM or MW.
2. Press and hold the Rewind or Forward button until the frequency display changes to rapid
run-through. The search will stop automatically when it finds a station with sufficient strength.
3. When the end of the frequency band is reached, it will recommence searching from the opposite
end of the frequency band.
Notes:
The automatic station search can be interrupted by briefly pressing the Stop button.
Manual station search
1. To move the frequency in step, briefly press the Rewind or Forward button.
The frequency changes in steps of 50kHz (FM) or 9kHz (MW).
2. When the end of the frequency band is reached, it will recommence searching from the opposite
end of the frequency band.
elite2_ib.indd 10
All manuals and user guides at all-guides.com
9
1/3/2011 17:48:06