Mode Of Operation; Maintenance And Environmental Protection - MeisterCraft MMF 1700 Traduction Du Manuel D'utilisation Original

5459190-Mauernutfr-man 29.01.14 08:45 Seite 52
9 – Mode of operation
The device is suitable for dry cuts only,
without the use of water.
Additional handle
The additional handle (10) serves to
ensure safe guidance of the tool during
sanding.
CAUTION! Always work with
both hands and the additional
handle!
Check the area you intend working on
for power lines, water and gas pipes.
After you have set the cutting depth and
width, switch the tool on and place the
front edge of the foot up against the
brickwork. Dip the cutting wheels down
slowly until the guide roller (15) and the
depth stop (5) are straight.
Guide the tool in the desired direction
and thus make the required groove.
The unit must always operate in counter
rotation. Thus, do not attempt to go in
the opposite direction. The tool may
otherwise be pushed uncontrollably out
of the cut.
CAUTION! Only cut in a straight
line! It is not possible to cut
curves!
At the end of the groove, swing the tool
out before switching it off.
52
All manuals and user guides at all-guides.com
CAUTION! Only set the machine
down after it has come to a
standstill!
You can now use the chisel (12) to
remove the remaining brickwork
between the grooves.
Laser projector (17) (Figure 7)
The beam from the laser projector
makes it easier to carry out straight cuts
a) along a pre-drawn cutting line on the
work piece
b) or by pointing it at a marked fixed
point on the work piece.
The range of the beam is approximately
65 cm, depending on the ambient lighting.
The laser projector is switched on/off as
required using the On/Off switch (19).
Changing the battery (Figures 8 + 9)
Remove the battery compartment
cover (20) of the laser projector (17).
Always replace used batteries in pairs.
Make sure the polarity (+/–) is correct.
You will need 2 x 1.5 V alkaline batteries
of type Micro/AAA (25).
10 – Maintenance and
environmental
protection
CAUTION! Before performing any
care or maintenance work,
disconnect from the power!
Clean the tool with a damp cloth only –
do not use solvents. Dry well.
Keep the ventilation slots free of dust.
Before each use, check the tool, the