Components; Correct Use - MeisterCraft MMF 1700 Traduction Du Manuel D'utilisation Original

5459190-Mauernutfr-man 29.01.14 08:45 Seite 44
Hand/arm vibrations
a Handle: 9,430 m/s
hv
Additional handle: 9,564 m/s
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use of
the power tool. These fluctuations will
depend on the way in which the
power tool is used.
Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which the
power tool is switched off and times
in which it is switched on, but is
running without load.)
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.
44
All manuals and user guides at all-guides.com
2
2
2
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
vicinity should thus also wear ear
defenders.
3 – Components
1 On/Off switch
1a Safety switch
2 Handle
3 Spindle lock
4 Protective hood
5 Depth stop
6 Setting screw for depth stop
7 Extraction duct
8 Vacuum support
9 Additional handle
10 Hexagonal wrench
11 Flange wrench
12 Flat chisel
13 Vacuum adapter
14 Cutting wheel
15 Guide roller
16 Clamping nut
Figures 4 + 5
21 Spindle
22 Tensioning disc
23 Sleeve
24 Spacer
Figures 8 + 9
17 Laser projector
18 Laser optic
19 Laser On/Off switch
20 Battery compartment lid
25 2 x Batteries
4 – Correct use
The wall chaser is used to cut pipe and
cable ducts in brickwork and cement.
This unit is only designed for private use.