Oceanic OCEACV2000 Guide D'utilisation page 17

Masquer les pouces Voir aussi pour OCEACV2000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SUPPORT INSTALLATION
1. According to fig.1, turn the body down with the bottom upward, and
the screw out onboard screws.
2. According to fig.2, remove the supports. Aim the buckle on the
support at the hole, push the supporting foot until the holes on
support coincides with the screw hole on the machine.
3. Penetrate the removed screws through the support holes and
tighten in the machine table.
4. After the installation is completed, turn the body upward for use.
OPERATING INSTRUCTION
Check before turning on the machine
1.
Check if the power wire is under good condition.
2.
The product adopts 220-240V~ 50Hz power supply,
before use, please confirm if the rated current of the
power socket meets the local requirements, otherwise,
please replace it with the qualified socket.
Put the machine on the flat surface
Please put the heater on the flat place, at least the surface
below the base of the heater must be flat.
Temperature Control Knob
Insert the plug into the power socket, then turn the
Temperature Control knob clockwise, when hearing the "poop"
sound (it means the temperature controller is on), adjust the
Temperature Control knob to the desired temperature level.
1

Publicité

Table des Matières
loading

Table des Matières