TABLE OF CONTENTS
Care & Cleaning..............................................................................................2
Warnings......................................................................................................... 2
Common Tools Needed.................................................................................. 2
Before Installation............................................................................................3
Warranty..........................................................................................................4
Rough-in Dimensions ....................................................................................14
THANKS FOR CHOOSING TOTO!
The mission of TOTO is to provide the world with healthy, hygienic and more
comfortable lifestyles. We design every product with the balance of form and
function as a guiding principle. Congratulations on your choice.
CARE & CLEANING
Your new showerhead is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with mild soap, rinsing
thoroughly with warm water and drying with a clean, soft cloth. Do not use
abrasive cleaners, steel wool or harsh chemicals, as these will dull the finish.
Failure to follow these instructions may void your warranty.
If any nozzles become clogged with mineral build up, rub gently with finger tips
to clean.
WARNINGS
For safe operation, please observe the following:
Recommended operating pressure:
Minimum pressure.........20 psi (138kPa), dynamic
Maximum pressure........80 psi (551kPa), static
It is suggested to use the temperature below 140°F(60°C).
Do not use steam for hot water supply.
Do not use the product at an ambient temperature below 32°F (0°C).
COMMON TOOLS NEEDED
Sealing tape
Screw driver
Adjustable wrench
2
BEFORE INSTALLATION
Observe all local plumbing codes.
Make sure the water supply is shut off.
Read these instructions carefully to ensure proper installation.
Make sure there are adequate mounting supports.
TOTO reserves the right to update the product design without notice.
Check to make sure you have the following parts indicated below:
Shower head
Hex wrench
(1.5mm)
INSTALLATION PROCEDURE
Shower arm
(sold separately
TS110MW16#$$)
Shower arm
(Sold separately
TS110MC16#$$)
Escutcheon
Ceiling mount
Wall mount
1. Slide escutcheon onto shower arm until flush to surface.
To make assembly easier, lubricate o-ring inside escutcheon with water.
2. Screw showerhead onto shower arm.
3. Tighten set screw.
CAUTION:
Product is heavy. Make sure there is adequate mounting support prior to
installation.
Thoroughly clean and remove debris from the water supply pipe before
installation to prevent clogging the spray outlet.
To avoid leakage, do not move the showerhead after installation.
Escutcheon
Disassembly tool
Gasket
Shower head
3