Using Oven Racks; Using The Partition - Samsung FE710DRS Manuel D'utilisation

USING OVEN RACKS
The racks have a turned-up back edge that prevents the racks from pulling out of the oven cavity.
To remove racks
1. Pull the rack straight out until it stops.
2. Lift up the front of the rack and pull it out.
To replace racks.
1. Place the end of the rack on the support.
2. Tilt the front end up and push the rack in.
USING THE PARTITION
• To use twin mode operation inserting partition.
• Can`t use self clean and steam clean mode when partition located in the cavity.
• Use the glove when you maintain the partition.
• You have to handle the partition on both hand.
To Enter the partition at cavity.
1. Insert partition at 5 level in cavity.
2. Push the partition to end of cavity.
3. You can see the "-" icon on the display.
CAUTION
FE710DRS_XAC_DG68-00334A-07_EN.indd 29
In order to remove or replace racks properly, follow the orders recommended in below.
Range displays "E-0C"
• Check the partition to see if it is installed correctly.
Operating the oven _29
05/11/2012 20:31:18