Electric Connection - Aquastic AQ30 Instructions De Montage Et D'utilisation

The outlet tube has to be placed vertically downwards and the blow-off button has
to be accessible. In the order of water flow, it contains the one-way valve, the
security valve and the outlet tube that has to be left open toward the air space.
4.2 If the water pressure in the system exceeds the value of 0.6 MPa temporarily,
a pressure reducing valve has to be mounted in front of the hot water tank. This
pressure reducing valve has to be purchased and mounted by the customer.
The pressure reducing valve has to be mounted in front of the combined
safety valve.
4.3 An arbitrary number of taps and mixing faucets can be mounted on the hot
water tank. The flow back of the hot water through the outlet towards the pipeline
system is blocked by the one-way valve, which is not an accessory of the hot
water tank.
4.4 Using the closing valve, the hot water tank can be disconnected from the
pipeline system.

5. ELECTRIC CONNECTION

5.1 The hot water tank should be connected to the electric system only through
permanent connection. It is forbidden to apply any wall socket.
5.2 The current of the electric system has to be connected to the hot water tank
through an all-pole disconnection device, which has at least 3mm separation
distance in all pole.
5.3 The diameter of the required electric system wire is: 1.5 mm
depending on performance as described on the data table.
The wires adequate for connection to the electric system are the following:
Adequate type: Alternative type:
H0 5 VVK (H0 5VVF)
H0 5 RRK (H0 5RRF)
H0 5 VVK (H0 5VVH)
Connection with wire protection tube is not allowed!
5.4 The electric connection wire has to be connected to the screwed connecting
points of the temperature controlling/reducing device.
5.5 The connecting wire has to be placed between the two parts of the bent
clamp, then it has to be fixed to the cable sheath base with the fixing screws.
5.6 It is forbidden to operate the hot water tank without any protective earthing.
The protective earthing has to comply with the instructions of the IEC 60364.
All manuals and user guides at all-guides.com
EN
10
2 2
– 2,5 mm ,