Malfunctions - Auping AVS Mode D'emploi

All manuals and user guides at all-guides.com

5. Malfunctions

While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Sparks fly when the
box spring control
system is being
plugged into the
transformer
Motor runs for a while
then stops
GB22
_04DU3_3903 - BW.pdf - pag.22
Cause
Caused by moving parts
touching each other.
The box spring is not
leveled because the
floor is not absolutely
flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose
when the bed was
moved.
The bed is not
positioned away from
the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
The plug is already in
the wall socket before
the box spring control
system is connected.
Faulty Hall sensor in
motor.
LET OP !!! Lage resolutie!
Search Solution
Apply Teflon spray.
Do not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
First connect the box
spring control system,
then put the plug into
the socket.
Set bed in horizontal
mode by alternately
adjusting up and down a
little at a time. Replace
motor.
January 23, 2009