Plug Electrical Panel; Connect Downdraft To Power; Install Cooking Appliance; Attach Endcaps To Downdraft - Bosch HDD80051UC Instructions D'installation

INSTALLATION

Plug electrical panel

Plug electrical panel cable into lower receptacle on side of
downdraft.

Connect downdraft to power

1. Plug the downdraft's power cord into the 3-pronged
receptacle. Make sure that the power cord is routed away
from the heat generated by the cooktop.
2. Check operation.
3. Remove all protective fi lm and packaging before operation.
In order to remove all protective fi lm and packaging, raise
the intake housing and remove the front panel to access
the fi lter area.

Install cooking appliance

Align the cooking appliance with downdraft and fasten
appliance in place following appliance instructions.
Note: Accurate alignment of cooking appliance and
downdraft is necessary to ensure that there is no
interference when air vent is raised and lowered. There
should be a gap of 1/32" - 1/16" (0.79 mm - 1.59 mm)
between the back of the cooktop and the front of the
downdraft cover.

Attach endcaps to downdraft

SPECIAL KEY
( )
INCLUDED
NOTE: Following procedure applies to both endcaps.
1. Use the included special key to loose the endcap
retaining screw.
2. Place the endcap over the bracket.
3. Use the included special key to tighten the endcap
retaining screw.
4. Check the operation of the downdraft.
ENDCAP
RETAINING
SCREW
English 21