JVC KD-DV5202 Manuel D'instructions page 17

PTY Standby Reception
PTY Standby Reception allows the unit to
switch temporarily to your favorite PTY
programme from any source other than AM.
To activate and select your favorite PTY
code for PTY Standby Reception, see page
40.
The PTY indicator either lights up or flashes.
• If the PTY indicator lights up, PTY Standby
Reception is activated.
• If the PTY indicator flashes, PTY Standby
Reception is not yet activated.
To activate PTY Standby Reception, tune in
to another station providing these signals. The
PTY indicator will stop flashing and remain
lit.
To deactivate the PTY Standby Reception,
select "OFF" for the PTY code (see page 40).
The PTY indicator goes off.
Tracing the same programme—
Network-Tracking Reception
When driving in an area where FM reception
is not sufficient enough, this unit automatically
tunes in to another FM RDS station of the
same network, possibly broadcasting the same
programme with stronger signals (see the
following illustration).
When shipped from the factory, Network-
Tracking Reception is activated.
To change the Network-Tracking Reception
setting, see "AF-REG" on page 40.
Programme A broadcasting on different
frequency areas (01 – 05)
Activating station selection—
Programme Search
Usually when you press the number buttons, the
preset station is tuned in.
If the signals from the FM RDS preset station
are not sufficient for good reception, this unit,
using the AF data, tunes in to another frequency
broadcasting the same programme as the
original preset station is broadcasting.
• The unit takes some time to tune in to another
station using programme search.
• See also page 40.
To check the current clock time while
listening to an FM RDS station
17