Intended Use - Worx WG217 Mode D'emploi

OPERATING INSTRUCTIONS
WARNING! Do not use the product without
attaching the guard and front handle.

INTENDED USE

This machine is intended to be used
domestically for cutting and trimming hedges
and bushes.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Extension cord retainer hook
OPERATION
Starting and stopping
WARNING: If any parts are missing,
damaged or broken, do not operate
your Hedge trimmer until all damaged parts
have been replaced or repaired. Failure to do
so could result in serious personal injury. DO
NOT USE WITHOUT HANDLE AND GUARD.
To start your hedge trimmer
10
To stop your hedge trimmer
Rotating the front cutting head
NOTE:
1. It is recommended to
disconnect the power
supply when rotating the
front blades.
2. Make sure the cutting head
is in the locked position
before starting the hedge
trimmer.
3. Make sure the lock button is
in the lock position before
starting the hedge trimmer.
4.5 AMP Electric Hedge Trimmer
Using your hedge trimmer
immediately. Never use your tool with a
damaged cord since touching the damaged
area could cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should be
replaced by a local approved Service Center.
Do not expose this tool to the rain.
Top cutting
FIGURE
Side cutting
See Fig. A
Lubricating the cutting blade
HOW TO USE YOUR HEDGE TRIMMER
Inspect the area to be cut before each use,
remove objects which can be thrown or
become entangled in the cutting blades.
Always hold the Hedge trimmer with both
hands and with the blade away from you
before turning it on.
Always keep the power cord behind the
See Fig. B
Hedge trimmer when in use. Do not place
it over the hedge that you are trimming
See Fig. C
where it may be cut by the blade.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade. (See Fig. E-F4)
Allow the cutting blades to reach full speed
before entering the material to be cut.
Always work going away from people and
See Fig. D
solid objects such as walls, large stones,
trees, vehicles etc.
If the blade stalls, immediately stop the
Hedge trimmer. Disconnect the Hedge
trimmer from the power source and clear the
jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Move the Hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to
feed into the cutting blade.
TOP CUTTING (See E)
Use a wide sweeping motion. A slight downward
tilt of the cutting blades in the direction of motion
gives the best cutting results.
WARNING: Check extension cords
before each use. If damaged replace
See Fig. E
See Fig.
F1,F2,F3, F4
See Fig. G
EN