Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

#LCK-SL42-D
PROPANE CONVERSION KIT
For model Slayton 42
Direct Vent Gas Fireplace
This fireplace is certified under U.S. and Canadian standards ANSI Z21.88-2017/CSA 2.33-2017, CSA 2.17-2017
IMPORTANT
THE CONVERSION SHALL BE CARRIED OUT BY A
MANUFACTURER'S AUTHORIZED REPRESENTATIVE,
IN ACCORDANCE WITH THE REQUIREMENTS
OF
THE
MANUFACTURER,
TERRITORIAL AUTHORITIES HAVING JURISDICTION
AND IN ACCORDANCE WITH THE REQUIREMENTS
OF THE CAN/CGA-B149.1 OR CAN/CGA-B149.2
INSTALLATION CODES.
CETTE CONVERSION DE GAZ DOIT ÊTRE EFFECTUÉE
PAR UN REPRÉSENTANT AUTORISÉ DU FABRICANT,
CONFORMÉMENT AUX EXIGENCES DU FABRICANT ET
DES AUTORITÉS PROVINCIALES OU TERRITORIALES
AYANT JURIDICTION, ET AUX EXIGENCES DES
CODES D'INSTALLATION CAN/CGA-B149.1 OU CAN/
CGA-B149.2.
WARNING
This conversion kit shall be installed by
a qualified service agency in accordance
with the manufacturer's instructions and
all applicable codes and requirements
of the authority having jurisdiction. If
the information in these instructions is
not followed exactly, a fire, explosion
or productions of carbon monoxide
may result, causing property damage,
personal injury, or loss of life. The
qualified service agency is responsible
for proper installation of this kit. The
installation is not proper and complete
until
operation
appliance is checked as specified in the
manufacturer's instructions supplied
with the kit. Refer to appliance owner's
manual or product data plate for proper
inlet and manifold pressure adjustments
and orifice sizing.
Hussong Manufacturing Co., Inc.
204 Industrial Park Drive, PO Box 577
Lakefield, MN 56150-0577, USA
PROVINCIAL
OR
of
the
converted
HUSSONG MANUFACTURING CO., INC.
READ ALL STEPS BEFORE STARTING INSTALLATION.
LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
This gas conversion kit installation instructions must be used in
conjunction with the installation and operation manual provided with
the appliance. Please read the appliance owner's manual completely
before performing any procedures in these instructions. All warnings,
precautions, and instructions outlined in the manual provided with the
appliance will continue to apply to these instructions.
AVERTISSEMENT
Ce kit de conversion doit être installé
par une agence d'entretien qualifiée,
selon les instructions du fabricant et
tous codes et règlements applicables
de l'autorité ayant juridiction. Le non-
respect de ces instructions peut créer un
incendie, une explosion ou la production
de monoxyde de carbone, et causer des
dommages matériels, des blessures
ou même la mort. L'agence d'entretien
qualifiée est responsable de la qualité
d'installation de ce kit. L'installation
ne sera conforme et complète qu'après
avoir vérifié le fonctionnement du
foyer converti, tel que spécifié dans les
instructions du propriétaire fournies
avec ce kit. Voir le manuel d'utilisation
ou la plaque signalétique de l'appareil,
pour les réglages de pressions d'entrée
et du manifold et les dimensions d'orifice
(injecteur) de brûleur/veilleuse.
Starting Serial Number 22 068529 12:
EN
FR
PG
6
SLA-42 • Rev. 1, 3/22
Report Number: 19-505

Publicité

Table des Matières
loading

Sommaire des Matières pour Kozy Heat Fireplaces LCK-SL42-D

  • Page 1 #LCK-SL42-D PROPANE CONVERSION KIT For model Slayton 42 HUSSONG MANUFACTURING CO., INC. Direct Vent Gas Fireplace This fireplace is certified under U.S. and Canadian standards ANSI Z21.88-2017/CSA 2.33-2017, CSA 2.17-2017 IMPORTANT THE CONVERSION SHALL BE CARRIED OUT BY A MANUFACTURER’S AUTHORIZED REPRESENTATIVE,...
  • Page 3 Table 1, Burner Orifice Size at Elevations 0-4,500’ (1,372m) Fuel Center Orifice Size Side Orifice Sizes Propane #52 (DMS) #67 (DMS) Burner ori ce FIGURE 1, Burner Orifice FIGURE 2, Converted Pilot and Pilot Injectors #LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...
  • Page 4 FIGURE 5, Burner Venturi Flame Modulation/ Propane/Natural Gas Switch Stepper Motor Connection SIDE VIEW (Fuel Setting) FIGURE 4, Control Module GLASS MEDIA GLASS MEDIA DAM BURNER COVER/MEDIA TRAY FIGURE 6, Glass Media Dam Installation #LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...
  • Page 5 FIGURE 8, Burner Ports Location and Correct Pilot Flame Appearance Ideal Flame Appearance Manifold pressure tap Inlet pressure tap FIGURE 7, Pressure Check Taps Lazy, yellow ames - no adjustment necessary FIGURE 9, Ideal Burner Flame Appearance #LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...
  • Page 6: Composants Du Kit De Conversion

    Tableau 1, Taille de orifice du brûleur aux altitudes 0-4500 pi (1372 m) Combustible Central Latéraux Propane nº 52 (DMS) nº 67 (DMS) FIGURE 2, Veilleuse convertie et orifices de la veilleuse Ori ce du brûleur FIGURE 1, L’orifice du brûleur LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...
  • Page 7: Conversion De La Valve De Contrôle De Gaz

    (moteur pas-à-pas) BRAISE DE VERRE du combustible) FIGURE 4, Module de contrôle BANDE DE RÉTENTION À RETENIR MÉDIA «MEDIA DAM» COUVERCLE DU BRÛLEUR/PLATEAU À MÉDIA («MEDIA TRAY») FIGURE 6, Bande de rétention LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...
  • Page 8: Tests De Pression À L'entrée

    Raccord de test de Raccord de test de pression du manifold pression d’entrée Jaunes et lentes - aucun ajustement nécessaire FIGURE 7, Raccords de test de pression FIGURE 9, Apparence idéale des flammes du brûleur LCK-SL42-D HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES...

Table des Matières