Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DO-429K
•
Take the lid off the ground coffee container
•
Fill the container with one spoon of ground coffee using the measuring spoon
supplied and carefully close the lid.
FILLING THE WATER RESERVOIR
•
Open the lid of the water reservoir completely.
•
Pull up the water reservoir by using the handle.
•
Fill the reservoir with cold water. Do not fill it higher than the MAX level
indicator located on the side of the reservoir.
•
Put the water reservoir firmly into its correct position and carefully close the lid.
•
You can of course fill the water reservoir without removing it.
•
Fill the water reservoir with a sufficient amount of water. If the water level is too
low, the water sensor
you add a sufficient amount of water to the tank.
•
Try to make sure that you do not switch the appliance on if the water reservoir is
empty and never fill the reservoir with warm or boiling water. Do not leave water
in the tank for several days. Use fresh water as much as possible.
•
Never remove the water reservoir while you are already brewing coffee. If
the water runs out during the process of making coffee the appliance will stop
automatically. The display
remind you to add water.
After you have refilled with water the appliance will finish off the coffee making
process. You can stop the coffee making process at any time by pressing the BACK
button
.
ESTABLISHING PRE-SETTINGS
After the device has been turned on, you press the Menu-icon:
icons to make your choice:
SETTINGS
Small Espresso
All manuals and user guides at all-guides.com
will flash and you will hear an acoustic signal until
will flash and you will hear an acoustic signal to
DISPLAY
To select the desired
amount of coffee, press
repeatedly
For the desired amount of
coffee beans, choose
60
. Press one of the
.
OPTIONS
40ml --> 50ml --> 60ml
or
.
Select
Two coffee beans indicates
stronger coffee.
Publicité
Table des Matières
