Additional Settings - Linea 2000 DOMO DO-429K Mode D'emploi

Cafetiere entièrement automatique

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

All manuals and user guides at all-guides.com

DO-429K

Place a coffee cup on the grid directly below the drip nozzle. You can slide the nozzle

upwards and downwards as desired, depending on the height of

your cup.

Keep a jug of fresh milk ready next to the appliance. Connect the

milk suction pipe to the milk foam control knob and dip the other

end into the milk. Turn the foam control knob to Latte. Always use

full-fat milk and store it at a temperature below 8°C.

Press on the Latte button.

Choose the number of cups within 5 seconds, 1 of 2. Standard is 1 cup; you must

press on

for two cups. The appliance will make your espresso. Your Latte will be

made.

Ground Coffee

If you selected ground coffee in the pre-settings the display will show the following:

The icon

will flash to remind you to add ground coffee. With ground coffee

added press on the

icon to make Latte. In

the accompanying table below, you can read the

volume of the selected amount of coffee per cup.

FLUSHING AFTER USING MILK

Every time you have made Cappuccino or Latte

the appliance will remind you to clean the internal

circuitry to remove milk residues. The

- button shows continually. To clean the

appliance, simply press on the

- button.

Attention!!! Insert the end of the milk suction pipe in a jug of clean water and place a

large container (250ml at least) under the nozzle button, to collect the flush water.

MILK FOAM AND HOT WATER

To make milk foam, always use full-fat milk and store it at a temperature below 8°C.

Keep a jug of fresh milk ready next to the appliance. Connect the milk suction tube to

the milk foam control knob and dip the other end into the milk.

If you want to make milk foam or hot water with your appliance, press the button

The display will show the

icon and the

button will flash.

For warm water press on the

button and the display will show

. .

You can use the

button to switch between milk foam or hot water.

Now you press on the

button. After 30 seconds of warming up the appliance

provides approximately 250ml of hot water. You can always stop prematurely by

pressing the

button. If you have been made milk foam, then rinse the appliance

afterwards as described above (FLUSH AFTER USING MILK).