Control Panel; Before The First Use - Linea 2000 DOMO DO725K Mode D'emploi

CONTROL PANEL

On/off button
18.
19. Hot water button
20. Single button: for 1 cup of espresso
21. Double button: for a double shot of espresso
or 2 cups
22. Grinder indicator light
23. Pressure gauge
24. Steam indicator lamp

BEFORE THE FIRST USE

· Check that all accessories for the device are present and that the unit is not damaged.
Flush out the pipes. First, allow the water to run through without adding ground coffee to the filter of
·
the portafilter. See section: 'use/coffee'. Afterwards, throw away the water.
· Flush out the steam nozzle. See section: 'use/hot water feature'. Afterwards, throw away the water.
· Clean all parts with a moist cloth.
USE
Press the on-off button; the appliance will start warming up. The indicator lights will flash. This warm-up
phase lasts about 50 seconds. If all indicator lamps are lit, the appliance has warmed up and goes into
standby mode.
If the unit is not used for 20 minutes, it will automatically go into sleep mode. You will hear a signal. Press
the on-off button on the unit to activate it and to enable the standby mode.
GRINDER
Placement
1. Place the bean reservoir on the machine and tighten into place. Pay attention to the markings on
the reservoir.
2. Place the grinder support against the rear wall of the machine, under the grinder. Slide the support
downwards so that it is secure.
3. Remove the lid from the bean reservoir. Add the beans by slowly pouring them into the reservoir. Do
not overfill the reservoir. Place the lid back.
Usage
Select the desired filter and push this into the portafilter.
1.
the small filter is for one espresso
·
the large filter is for 2 cups or a double espresso
·
Insert the plug in the power socket and press the on-off button. Make sure that the steam knob is in
2.
the off position.
44
DO725K
18 19
22
1
20 21
23
2
24