Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
CUPBOARD MOUNTING INSTALLATION
Drill a 130mm diameter and four 3.5mm diameter hole as below
picture.
ATTENTION: If your cooker hood works at circulating-air mode,
it is not necessary to drill 130mm diameter hole.
Use the 4 screws to fix the cooker hood to a kitchen cupboard.
Check that your fixings are correctly located, by temporarily
fitting the cooker hood. If correct, fit the unit into position.
Tighten the screws if neessary.
100
WALL MOUNTING INSTALLATION
To mount on the wall, drill two 10mm diameter holes 538mm
with the vent hole on the top of the cooker hood in the middle
as below picture. Make sure the hood is aligned directly over
the hob.
Insert two plastics wall plugs(supplied) into the holes.
Insert two screws into the upper two plastic wall plugs and
480
70
180
EN-14
130
Publicité
Chapitres
Dépannage
