Dometic RH430LD Instructions De Montage Et De Service page 19

RH4xxLD, RH4xxLG
9 Troubleshooting
Problem
Device is not cooling
(the cooling unit at
the back of the
device is cold).
Device is not cooling
(the cooling unit at
the back of the
device is warm).
The devices cooling
performance is poor.
Frost is forming inside
the device.
EN
All manuals and user guides at all-guides.com
Possible cause
The device plug is not
plugged in.
No voltage present in the
AC voltage socket.
The device is in its defrost-
ing phase.
The electronics or the sen-
sor is defective.
The heating element is
defective.
The device is not level.
The device was only
switched on a short while
ago.
The cooling unit is
defective.
The cooling unit is not
sufficiently ventilated.
The device is exposed to
heat or direct sunlight.
The device door does not
close tightly.
The device was stocked a
short while ago.
The device door does not
close tightly.
Troubleshooting
Suggested remedy
Plug the device plug in.
Check fuse or try using another plug
socket.
Check again if the device is cooling
after 2 hours as the defrosting phase
lasts 2 hours.
This can only be repaired by an author-
ised customer services unit.
This can only be repaired by an
authorised repair centre.
Level the device using a spirit level.
Let the device run for 5 to 6 hours.
This can only be repaired by an
authorised repair centre.
Check that the ventilation grids are not
covered.
Check that device has been installed
in accordance with fig. 2, page 3.
Relocate the device.
Check if the door is installed correctly.
An authorised repair centre can install
a new door seal if necessary..
Check the temperature after 5 to
6 hours.
Check if the door is installed correctly.
An authorised repair centre can install
a new door seal if necessary.
19