Additional Information - D-Link DWC-1000 Guide D'installation Rapide

Figure 12. Wireless Default Radio Configuration
3. Wireless Default VAP Configuration -
Enter the SSID network name, then select a
security method. If you select Static WEP or
WPA Personal, enter a secure passphrase for
your WLAN.
Figure 13. Wireless Default VAP Configuration
4. Valid Access Point Summary -
Enter the MAC address of the AP you want to
manage.
Note: If a password was set for the AP while
in standalone mode, this requires APs to be
authenticated before they can associate with
the controller. Type the same password that
was set in standalone mode in the Authenti-
cation Password box. If no password was set
in standalone mode, you do not need to enter
a password here.
The valid password range is between 8 and
63 alphanumeric characters. The password in
this field must match the password configured
on the AP.
All manuals and user guides at all-guides.com
5. Save Settings and Connect -

Additional Information

You can refer to the additional documentation
found in the PDF format on the accompanying
master CD or visit the D-Link website online
for more information on how to configure the
DWC-1000 device.
D-Link Wireless Controller User Manual
This manual describes the general operation and
control of the Wireless Controller firmware which
drives and controls the Wireless Controller series
hardware. It includes examples of how to carry
out typical administrative tasks such as setting up
Rogue AP detection and how to use the Wireless
Controller in various scenarios.
D-Link Wireless Controller CLI Reference Guide
This document describes all available text-based
commands that can be used on an RJ-45 to
DB-9 Console or SSH interface to configure the
Wireless Controller.
Online Support
If there are any issues which are not in the user
manual, please visit http://support.dlink.com,
which will direct you to your appropriate local
D-Link website.
Warranty Information
The D-Link Limited Lifetime Warranty information
is available at http://warranty.dlink.com/
Figure 14. Valid Access Point Summary
When the WLAN Connection Setup Wizard
has been completed, click the Connect button
to save your settings and connect.
Figure 15. Setup Complete
D-Link Wireless Controller  7