Additional Information - D-Link DWC-2000 Mode D'emploi

Figure 14. Configure AP
Valid Access Point Summary: Enter the
MAC address of the AP you want to manage.
Figure 15. Enter MAC addresses
3. Save Settings and Connect - When the
WLAN Connection Setup Wizard has been
completed, click the Connect button to save
your settings and connect your APs.
Figure 16. Summary

Additional Information

You can refer to the additional documen-
tation on the accompanying master CD
or you can visit
online for more support on how to configure
your DWC-2000.
• D-Link Wireless Controller User Manual
This manual describes the general opera-
tion and control of the wireless controller
firmware which drives and controls the
wireless controller hardware. It includes
examples of how to carry out typical ad-
ministrative tasks such as setting up Rogue
AP detection and how to use the wireless
controller in various scenarios.
• D-Link Wireless Controller CLI Refer-
ence Guide
This document describes all available text-
based commands that can be used on an
RJ-45 to DB-9 Console or SSH interface to
configure the wireless controller.
Online Support
If there are any issues which are not in the user
manual, please visit http://support.dlink.com,
which will direct you to your appropriate local
D-Link support website.
Warranty Information
The D-Link Limited Lifetime Warranty informa-
tion is available at http://warranty.dlink.com/
http://support.dlink.com
7