Salda Stouch Notice Technique page 40

EN
Installation
1. Separate the cover form the casing as in pic. 1,2;
2. Connect the cable to the controller
2.1- standard cable connection
PIN1 - +24V
1
4
PIN2 - B+
PIN3 - A-
PIN4 - COM
PIN1 - +24V
1 2 3 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
2.2 - spec connection (see "8 pin connection").
3. Put the cover at the intended location on the wall and mark places for the drilling, pic., 3,4;
4. Drill 5 mm holes at the marked places for nylon plugs and the hole throughout the wall to install the cable.
NOTE: the hole throughout the wall is necessary to connect the plug in cable from the other side of the wall. The
diameter of the hole should correspond the size of cable plugs.
5. Place 2 nylon plugs into 5 mm holes.
NOTE: metal plugs included into package also can be used pic. 5.
6. Screw the cover to the wall with the screws 2,9 x 16 DIN7981C included into package. Pic. 6
40
All manuals and user guides at all-guides.com
www.salda.lt