Lighting The Burners - EAS ELECTRIC EMH46RN Manuel D'instructions

Lighting the burners

To obtain a flame more easily, light the burner before
placing a cooking utensil on the pan stand.
To light a burner, proceed as follow: for Version with lighting
integrated in the
burner
"maximum flow" setting symbol, or press the button if the
appliance has individual lighting.
After lighting the flame, keep the knob pressed for about 10
seconds: this time is necessary to heat up the "thermocouple",
(Fig.1-C) and activate the safety valve, which would otherwise cut off
the gas flow.
Then check that the flame is even and turn the control knob
to adjust the flame as required.
In the instance of a power cut, place a flame near the burner
and proceed as already described.
If the flame does not light after a few attempts, check that the
"burner cap" and "flame cap" are correctly positioned. To turn off the
flame, turn the control knob clockwise to the
B efore removing pans from the burners, always lower or turn off
the flame.
For correct use of the hob
For lower gas consumption and better
bottomed pans of dimensions suitable for the burners, as shown in
the table on the right. Also, as soon as a liquid comes to the boil
take care to turn the flame down to a level that will just keep it
boiling.
B urner
Large (rapid)
Medium (semi-rapid)
Small (Auxiliary)
Triple Flame
During cooking processes involving fats or oils, watch your
foods carefully because these substances may catch fire if
brought to high temperatures.
control knob push the knob of the
fully down and turn it
efficiency:
minimum
diameter
180mm
120mm
80mm
220mm
8
anticlockwise to the
symbol.
●
Use only flat-
maximum
diameter
220mm
200mm
160mm
260mm
V.1