Cautions; Connecting The Hob To The Mains Power Supply - EAS ELECTRIC EMIH320-3F Manuel D'instructions

9.6 Cautions

1. The induction hotplate must be installed by qualified
personnel or technicians. We have professionals at your
service. Please never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher,
fridge, freezer, washing machine or clothes dryer, as the
humidity may damage the hob electronics
3. The induction hotplate shall be installed such that better
heat radiation can be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface
shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive
must be resistant to heat.
6. A steam cleaner is not to be used.

9.7 Connecting the hob to the mains power supply

This hob must be connected to the mains power supply
only by a suitably qualified person. Before connecting
the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power
drawn by the hob.
2. The voltage corresponds to the value given in the
rating plate
3. The power supply cable sections can withstand the
load specified on the rating plate.
To connect the hob to the mains power supply, do not use
adapters, reducers, or branching devices, as they can cause
overheating and fire. The power supply cable must not touch
any hot parts and must be positioned so that its temperature
will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring
system is suitable without alterations.
Any alterations must only be made by a qualified electrician.
The power supply must be connected in accordance with the
applicable regulations. The connection method is shown below:
31
V.2