Thermal Protection - Hoover ONEPWR BH15020 Guide De L'utilisateur

Masquer les pouces Voir aussi pour ONEPWR BH15020:

Guide de l'utilisateur (2 pages)

Guide de l'utilisateur (30 pages)

Guide de l'utilisateur (2 pages)

Table des Matières

Les langues disponibles

Care of Brush Roll and Nozzle

See Figure 9, page 11

CAUTION!

To reduce the risk of personal injury from moving parts,

turn power switch off and remove battery pack before

cleaning or servicing.

• Once the brush roll has been rinsed using the tray,

remove the nozzle cover by squeezing the latches and

lifting off.

• Lift up on the tab to remove the brush roll. Place in rack on

storage tray and allow to dry completely before reinstalling.

• Rinse nozzle cover and allow to dry.

• Wipe any remaining reside from the brush roll chamber

and hose with a rag.

• To reassemble, align brush roll end to the side of the

foot and lock into place by pressing down on the tab end.

• Replace the nozzle cover by aligning and pushing

downwards until it clicks.

NOTICE!

A thermal protector has been designed into your clean-

er to protect it from overheating. When the thermal

protector activates the cleaner will stop running.

• If this happens proceed as follows:

1. Turn cleaner off and remove the battery pack.

2. Empty dirty water tank.

MAINTENANCE (CONTINUED)

Filter Care

See Figure 10, page 11

To reduce the risk of personal injusry, turn power switch

off and remove battery pack before cleaning or servicing.

• Regularly clean the dry filter in order to maintain per-

formance. The filter is located in the top of the dirty

water tank.

• Access the filter by removing the dirty water tank. Press

down on the release latch on the front of the tank and

pull the tank away from the unit.

• Lift up on the tab to remove the filter.

• Hand wash with warm water and mild detergent.

• Dry the filter completely before reassembling (minimum

of 24 hours).