GYS GYSFLASH 30.12 PL Mode D'emploi page 9

• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse
the affected part of the body with plenty of water and seek
immediate medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery.
• The terminal of the battery that is not connected to the car
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel line.
The battery charger must be connected to the power supply
network.
• After the charging process, disconnect the battery charger
from the power supply network and remove the connector
from the car frame and then the connector from the battery, in
this order.
Connection:
• Class I device
• This device must be connected to an earthed power supply
• Connection to the mains must be made according to the
national installation regulations.
Maintenance:
• If the power supply cable is damaged, it must only be
replaced by a cable specified or supplied by the manufacturer
or its after-sales service.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations
•The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
GYSFLASH 30.12 PL EN
9