Amana AEC2000 Manuel Du Propriétaire page 9

To change the amount of time or the power level for a preset pad.
Pads 1 through 0 can be programmed for preset cooking cycles.
1. Open oven door.
• displays.
• If door is closed or STOP pad is pressed before programming is
complete, changes are discarded and microwave exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and
mode.
3. Press pad to be reprogrammed.
• and cooking time display.
• A number displays with
4. Enter cooking time by using the number pads.
5. Press POWER LEVEL pad to change power level if desired.
• Use the number pads to change power level to a lower power
setting.
6. Press START pad to set new programming to the pad.
• If START is not pressed, changes will not be saved.
P:0
• displays
7. Press STOP pad or close oven door to exit programming mode.
Stage cooking allows consecutive cooking cycles without interruption.
Four different cooking cycles can be programmed into a memory pad.
To use stage cooking:
1. Open oven door.
2. Press and hold pad 1 for approximately 5 seconds.
• Microwave beeps and
3. Press pad to be reprogrammed with stage cooking.
• and cooking time display.
• A number displays with
4. Enter cooking time by using the number pads.
5. Press POWER LEVEL pad to change power level if desired.
• Use the number pads to change power level to a lower power
setting.
6. Press TIME COOK pad.
• Display briefly shows the pad number that is being programmed
and the stage number to the upper right.
• Display changes to cook time and power level for the next stage.
7. Enter cook time and power level as in steps 4 and 5.
• To enter another cooking stage for that pad, press TIME COOK pad
again.
• Up to four different stages can be programmed.
8. Press START pad to set new programming changes to the pad.
All manuals and user guides at all-guides.com
P:0
displays. Oven is in programming
if it is less than full power.
P:0
displays. Oven is in programming mode.
if it is less than full power.
If the door is closed or the STOP pad is
pressed before programming is
complete, changes are discarded and
microwave exits programming mode. To
save your programming changes, press
the START pad at the end of the
programming sequence.
When the microwave is not running at
full power, a single digit is displayed
next to COOK LEVEL. This digit
represents a percentage of full power.
Level 8 would be 80%. Level 3 would
be 30%. If no number is displayed, the
microwave is at full power.
To add more time to a preprogrammed
cooking cycle, press the pad again to
restart the cooking sequence. To add
more time to a manual cooking cycle in
progress, simply press in the time
desired using the numbered pads and
press START. The newly entered time
will be displayed as remaining cooking
time.