Fama 410.009 Mode D'emploi page 12

PRODUCTS IDENTIFICATION TABLE WITH MINCER GROUP IN ALUMINUM
410009 en fr de ma 2017
DISINFECTION
 Use detergents with PH neutral not oxidizing
 If the hot water is used (> 60°C) use exclusively demineralised water.
 If other products are used, these ones must be adequate to the material type.
For the machines with aluminium parts or in cast iron (see following table) it is possible to use
peracetic acid products.
PERIODS OF LONG INACTIVITY
 During the machine long inactivity periods provide to pass vigorously on all steel surfaces
(especially if stainless) a clothes soaked of Vaseline oil so that to spread a protective veil.
THINGS DA NON FARE BEFORE OR DURING THE CLEANING:
 Enter towards the moving elements without to be previously checked of their stop;
 Enter towards the moving elements without have stopped it in safety stop (blockage in zero
position of the electric feeding sectioning devices)
PRODUCTS NOT TO USE:
 Compressed air with jets towards the zones with flour warehouses and in general towards the
machine;
 Vapor equipment;
 Detergent that contains CLORO (also if diluted) or its compounds as: the bleach, the muriatic
acid, products to clear the drain caustic soda, products for the marble cleaning, in general
decalcifying, etc ... can attack the steel composition, staining and oxidizing it unavoidable. The
only above described products fumes can oxidize and in any case corrode the steel;
 Steel wool, brushes or abrasive discs produced with other metals or alloys (ex. Common steel,
aluminum, brass, etc...) or tools that have previously cleaned other metals or alloys, that except
to scratch the surface.
 Detergents in abrasive dust;
 Fuel, solvents or inflammable and/or corrosive fluids;
 Substances used to clean the silver.
ALUMINUM
MOD
(Codes)
TS8 FTSM101
TI8 FTSMI101
TG8 FTGM102
TGI8 FTGMI102
12