Russell Hobbs 24440-56 Mode D'emploi page 6

4. Pull the anti -scale cartridge vertically out of the reservoir. Note that the cartridge may contain water
when it is removed (Fig A).
5. Fit the new cartridge and push it down firmly into the reservoir.
6. Refill and refit the reservoir.
7. Plug in your steam generator.
8. Once the appliance is ready, pull the steam trigger until the steam is being produced. This will prime
the system.
Important: Using the appliance without changing the cartridge can cause a reduction in the generated
steam output and damage the appliance. The guarantee will not cover damage caused to the appliance
by not changing the anti- scale cartridge when required.
REPLACEMENT ANTI-SCALE CARTRIDGES
Contact your local service agent with the model number for information on how to purchase replacement
anti-scale cartridges. See the enclosed guarantee card for details.
FILTER
We recommend that you remove and clean the filter every 6 uses depending on the water hardness in
your area. The warning light/reset button will flash to remind you that the filter needs cleaning. Doing this
will extend the life of the unit.
To remove the filter:
1. Unplug the appliance and let it cool down.
C Allow your steam generator to cool down for at least 1 hour until the soleplate is cold.
2.
3. Remove the reservoir from the front of the unit. The filter is behind the reservoir.
4. Turn the filter anticlockwise and remove it (Fig B).
5. Rinse the filter under a tap.
6. Refit the filter and tighten it firmly.
7. Reset the reminder light.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
6