Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEAM IRONING
If you intend to use steam, the temperature setting must be at l or higher.
1.
2.
Use the steam control to select the amount of steam you want ( m= low, l= medium, h= high).
3.
Squeeze the steam button to produce steam, release it to stop.
NOTE: When you first start your steam station and pull the trigger for steam ironing, there will be a
delay as your steam station pumps water from the reservoir to prime the system. This is normal
and may take 20-30 seconds. This will also happen after refilling the reservoir.
DRY IRONING
You can dry iron by just not pressing the steam button, but if you want to make sure you don't press it
accidentally, then you should iron with an empty reservoir. You can do your dry ironing first, then switch
off, fill the reservoir and do your steam ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•
Check that there's adequate ventilation behind the fabric otherwise moisture may build up causing
mildew.
•
Check that there's nothing behind the fabric that may be damaged by the steam.
•
Check that pockets, turn-ups, and cuffs are empty.
Set the temperature control to max.
1.
2.
Hold the iron close to (but not touching) the fabric.
We recommend using the steam button to produce steam for smaller areas, as it gives you better control.
AFTER USE
1.
Put the iron on top of the base unit and turn the temperature control to •.
Set the on/off sw itch to O and unplug the base unit.
2.
3.
Empty the reservoir.
4.
Let the iron cool down completely before cleaning it, moving it, or storing it away.
5.
The steam pipe can be coiled together and placed into the hose clip.
6.
Wrap the mains cable around the steam generator in an anti-clockwise direction then slot the plug
into the socket (Fig C).
7.
The water reservoir must be emptied when storing your steam station vertically.
CARE AND MAINTENANCE
1.
Unplug the base unit, and let the appliance cool down fully.
2.
Wipe outer surfaces with a damp cloth.
3.
Remove spots from the soleplate with a little vinegar.
4.
Take care not to scratch the soleplate.
ANTI-SCALE CARTRIDGE
To extend the life of the appliance and to avoid problems with lime scale, your steam generator is fitted
with an anti-scale cartridge. The life of the anti-scale cartridge depends on the frequency of use and the
hardness of the water in your area. In a soft water area this should be about 100 uses. Do not put any
descaling products (including vinegar) into the reservoir. This can damage the appliance.
To replace the cartridge:
1.
Switch off and unplug your steam generator.
2.
Allow your steam generator to cool down for at least 1 hour until the soleplate is cold.
3.
Remove the reservoir from the front of the unit.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE
Publicité
Table des Matières
