Follow These Steps When Battery Is Outside Vehicle; Grounding And Ac Power Cord Connections - Proseries PSW-2035 Guide D'utilisation

7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE

A SPARK NEAR THE BATTERY MAY
CAUSE A BATTERY EXPLOSION. TO
REDUCE THE RISK OF A SPARK NEAR
THE BATTERY:
7.1 Check polarity of battery posts. POSITIVE
(POS, P, +) battery post usually has a larger
diameter than NEGATIVE (NEG, N, –) post.
7.2 Attach at least a 24-inch-long 6-gauge
(AWG) insulated battery cable to
NEGATIVE (NEG, N, –) battery post.
7.3 Connect POSITIVE (RED) charger clip to
POSITIVE (POS, P, +) post of battery.

8. GROUNDING AND AC POWER CORD CONNECTIONS

This battery charger is for use on a
nominal 120 volt circuit and has a
grounded plug. The charger must be
grounded, to reduce the risk of electric
shock. The plug must be plugged into
an outlet that is properly installed and
grounded in accordance with all local
codes and ordinances. The plug pins
must fit the receptacle (outlet). Do not
use with an ungrounded system.
DANGER: Never alter the AC cord or
plug provided – if it does not fit the outlet,
have a proper grounded outlet installed
by a qualified electrician. An improper
connection can result in a risk of an
electric shock or electrocution.
NOTE: Pursuant to Canadian
Regulations, use of an adapter plug
9. FEATURES
2
1
All manuals and user guides at all-guides.com
7.4 Position yourself and free end of cable as
7.5 Do not face battery when making final
7.6 When disconnecting charger, always do
7.7 A marine (boat) battery must be removed
3
1. Engine Start/35A
2. OFF/2A
3. Clamps
4
4. Ammeter
5. Wheel
5
4
• •
far away from battery as possible – then
connect NEGATIVE (BLACK) charger clip
to free end of cable.
connection.
so in reverse sequence of connecting
procedure and break first connection while
as far away from battery as practical.
and charged on shore. To charge it
onboard requires equipment specially
designed for marine use.
is not allowed in Canada. Use of an
adapter plug in the United States is not
recommended and should not be used.
USING AN EXTENSION CORD
The use of an extension cord is not
recommended. If you must use an
extension cord, follow these guidelines:
• Pins on plug of extension cord must be
the same number, size, and shape as
those of plug on charger.
• Ensure that the extension cord is properly
wired and in good electrical condition.
• Wire size must be large enough for the AC
ampere rating of charger, as specified:
Length of cord (feet) 25
AWG* size of cord 10
*AWG-American Wire Gauge
Charge Rate Toggle Switch
Charge Rate Toggle Switch
50 100 150
10 10 8