Preparing To Charge; Charger Location; Dc Connection Precautions - Proseries PSW-2035 Guide D'utilisation

3. PREPARING TO CHARGE

3.1 If necessary to remove battery from
vehicle to charge, always remove
grounded terminal from battery first.
Make sure all accessories in the vehicle
are off, so as not to cause an arc.
3.2 Be sure area around battery is well
ventilated while battery is being charged.
3.3 Clean battery terminals. Be careful to
keep corrosion from coming in contact
with eyes.
3.4 Add distilled water in each cell until
battery acid reaches level specified by
battery manufacturer. Do not overfill.

4. CHARGER LOCATION

4.1 Locate charger as far away from battery
as DC cables permit.
4.2 Never place charger directly above
battery being charged; gases from
battery will corrode and damage charger.

5. DC CONNECTION PRECAUTIONS

5.1 Connect and disconnect DC output clips
only after setting any charger switches to
"off" position and removing AC cord from
electric outlet. Never allow clips to touch
each other.
6. FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE
A SPARK NEAR THE BATTERY MAY
CAUSE A BATTERY EXPLOSION. TO
REDUCE THE RISK OF A SPARK NEAR
THE BATTERY:
6.1 Position AC and DC cords to reduce risk
of damage by hood, door, or moving
engine part.
6.2 Stay clear of fan blades, belts, pulleys,
and other parts that can cause injury to
persons.
6.3 Check polarity of battery posts. POSITIVE
(POS, P, +) battery post usually has larger
diameter than NEGATIVE (NEG, N,–) post.
6.4 Determine which post of battery is
grounded (connected) to the chassis. If
negative post is grounded to chassis (as in
most vehicles), see (6.5). If positive post is
grounded to the chassis, see (6.6).
6.5 For negative-grounded vehicle, connect
POSITIVE (RED) clip from battery charger
to POSITIVE (POS, P, +) ungrounded post
of battery. Connect NEGATIVE (BLACK)
All manuals and user guides at all-guides.com
3.5 Study all battery manufacturer's
3.6 Determine voltage of battery by referring
4.3 Never allow battery acid to drip on
4.4 Do not operate charger in a closed-in
4.5 Do not set a battery on top of charger.
5.2 Attach clips to battery and chassis, as
6.6 For positive-grounded vehicle, connect
6.7 When disconnecting charger, turn
6.8 See Calculating Charge Time for length
3
• •
For a battery without removable cell
caps, such as valve regulated lead acid
batteries, carefully follow manufacturer's
recharging instructions.
specific precautions while charging and
recommended rates of charge.
to car owner's manual and make sure
that output voltage selector switch is
set at correct voltage. If charger has
adjustable charge rate, charge battery
initially at lowest rate.
charger when reading electrolyte specific
gravity or filling battery.
area or restrict ventilation in any way.
indicated in sections 6 and 7.
clip to vehicle chassis or engine block
away from battery. Do not connect clip to
carburetor, fuel lines, or sheet-metal body
parts. Connect to a heavy gauge metal
part of the frame or engine block.
NEGATIVE (BLACK) clip from battery
charger to NEGATIVE (NEG, N, –)
ungrounded post of battery. Connect
POSITIVE (RED) clip to vehicle chassis
or engine block away from battery. Do
not connect clip to carburetor, fuel lines,
or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or
engine block.
switches to off, disconnect AC cord,
remove clip from vehicle chassis, and
then remove clip from battery terminal.
of charge information.