Replacing The Spool; Cutting Grass; Cleaning And Maintenance; General Maintenance - Grizzly Tools ART 2020-25 Li Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
All manuals and user guides at all-guides.com

Replacing the spool

WARNING. Danger of injury!
• Do not cut moist or wet grass.
• Before starting the unit, make
sure that the spool is not touch-
ing any stones, scree, or other
foreign objects.
• Switch on the trimmer before
you approach the grass that is
to be cut.
• Do not overload the trimmer
during operation.
• Avoid contact with obstacles
(stones, walls, fences, etc.). The
cutting inserts would wear out
rapidly.
• Avoid using the device in bad
weather, especially if there is a
danger of lightning!

Cutting grass

Cut tall grass by a series of levels from
top to bottom.
Lawn edge trimming
Setup for edge trimming:
To trim lawn edges, slowly move the appli-
ance along the lawn edges.
Handle rod: 180° (see
Cutting angle position 5
ƒ
(see
)
Spacer bow in parking position
Cut the grass by
swaying the trim-
mer sideways to
the right and left.
Cut slowly while
the trimmer is tilted
forwards by ap-
prox. 30°.
)
Cleaning and
maintenance
Warning! Risk of injury from
moving dangerous parts!
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before do-
ing any servicing, remove the battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
may otherwise irreparably damage the
appliance.
After every trimming session, remove
grass and soil from the protective
cover and the trimming assembly.

General maintenance

Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts. Ensure
that the screws in the cutting device
are firmly in place.
Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
GB
53

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Art 2020-25 li set

Table des Matières