Dust Extraction; Switch On And Off - Dexter 900BS2.51 Manuel D'instructions

5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION
1.
Plug the sander into a power point and with the sander belt tight, press the trigger
switch and then release it. The belt rotates for a short period.
2.
Whilst the belt is running, adjust the tracking adjustment knob to align the belt to the
centre of the roller.
3.
Repeat the trigger action and tracking adjustment until the belt is correctly aligned.
4. Run the sander for a minute or so to ensure correct alignment before using the sander on
a workpiece.

Dust extraction

We recommend the use of the dust extraction facility at all times. Simply slide the dust bag
onto the dust extraction port. For longer periods of use or on large pieces of work, it is
advisable to use a suitable vacuum cleaner.
6. OPERATION

Switch on and off

WARNING: Always check that the power supply is the same as that
indicated on the nameplate of the tool.
To start the sander, press the trigger switch.
To stop the sander, release the trigger switch.
If you press the lock on button while the trigger switch is depressed, the switch is kept in
the operating position. This is convenient when continuous operating for extended
periods of time is required.
To release the lock on button, press and release the trigger switch.
NOTE:
The sanding performance and the surface quality obtained depend mainly on the choice
of the sanding belt and the pre-selected belt speed. The higher the belt speed, the
greater the material removal and the smoother the sanding surface becomes. Only
perfect sanding belts ensure a good sanding job and are gentle on the power tool. Work
with minimal pressure to increase the life of the sanding belts. The weight of the power
does not result in better sanding performance, but in more wear and tear on the power
tool and the sanding belt.
FR
ES
PT
IT
EL
PL
UA
RO
EN
149