Klarstein BELLAVITA ESPRESSO Mode D'emploi page 20

EN
20
3 Fill water into the water tank till Max mark. Never overfill the Max mark!
Select the desired filter and insert it to the porta-filter.
4 Use the measure scoop to measure the quantity of fine ground coffee powder to
your desired filter. Evenly press down the coffee powder into the filter with the flat
end of the measure scoop.
5 Insert the porta-filter in the machine with the handle pointing to the left. Turn the
handle to the right until it locks well with the shower head.
6 Place the cup onto the drip tray, and right under the coffee outlet.
7 Rotate the knob to coffee position. Press down coffee button (single or double cup).
The button will start to flash. The unit will start the pre-brewing for 3 seconds, and
then coffee brewing.
8 The unit will stop automatically when coffee brewing finished. Coffee button will
illuminate.
9 During coffee brewing, you can press the coffee button again to stop the operation
if you like.
10 Rotate again the knob to the "0" position to enter Standby mode.
1 1 Remove the porta-filter clockwise to detach.
12 Clean the porta-filter and dry it after use.
13 Now you can enjoy your delicious coffee!
NOTE: Rotate the knob to the "0"position after coffee brewing, will help to remove the
porta-filter easily.
Milk Frothing
Note: The unit will dispense a small amount water to the drip tray, when the machine
is in Standby mode or preheating mode for steam function, and the knob is rotated
to the "0" position. This is normal.
1 Rotate the knob to the "0" position. Press down the steam button for pre-heating.
The button will flash during preheating. The light will stop flashing and remain on
steadily while finishing preheating.
2 Pour desired amount of milk into the milk jug. Place the milk jug under the steam
tube & nozzle.
NOTE: The milk must be at refrigerator temperature (not hot!).
3 Dip the steam nozzle into the milk. Rotate the knob to the steam position. The steam
button will illuminate. The unit will start making steam out of the steam tube &
nozzle.
4 Rotate the milk jug with slow movements from the bottom upwards. Until your
desired foaming is reached, rotate the knob back to the "0" position and your milk
froth is ready with steam button light off, two coffee buttons light on.
5 Remove the milk jug away. Use a damp cloth to remove the milk residue on the
steam tube & nozzle.