First Use; Charging Process - Beyerdynamic MCW DIGITAL 200 Notice D'utilisation

5. LE-D 10 Charger in MCW-D 10 Case
With the integrated LE-D 10 charger in the MCW-D 10 transport case, it is possible to charge up to 10 microphone unit
batteries. The battery state is indicated on the outside of the case.
The MCW-D 10 transport case can be extended with more LE-D 10 chargers for 10 microphone units each.
Safety Information
• When installing the unit make sure that the plugs can be accessed easily.
• The unit must be connected to an isolated ground receptacle.
• Never expose the unit to water or excessive humidity. Do not install near swimming pools, spas, in a wet basement or
in other excessively humid environments.
• Never put any objects filled with liquids (e.g. vases or drinking vessels) onto the unit.
• Do not install or use this unit near sources of high heat, such as radiators, heat registers, flood lamps, spotlights, stoves,
or other appliances.
• Always route cables running to the unit where they will not be pinched or cut by heavy or sharp objects.
• Verify that the voltage rating of the unit matches that of the AC mains outlet you are to use. If you connect the unit
to the wrong voltage, you may seriously damage it.
• This unit needs a sufficient ventilation. Therefore, never cover the ventilation grilles. Leave a minimum distance of
20 cm around the unit.
• Never place burning objects (e.g. candles) onto the unit.
• Do not remove the foam material from the LE-D 10 charger. There are no parts inside the LE-D 10 charger that need
servicing.

5.1 First Use

To achieve a 100% battery capacity all microphone units should have 2 complete charging cycles (charging and discharging)
at least. Only after several charging and discharging cycles the rechargeable batteries will achieve their full capacity.

5.2 Charging Process

1. Connect the charger to AC power and switch it on. The LED on the switch will illuminate.
2. Put the switched-off microphone units into the charging compartments. If microphone units are switched on, they are
switched off automatically. When the microphone units are used again, they must be switched on.
3. The charging process is indicated by the green LEDs on the outside.
a) ___ ___ ___ __ LED is flashing slowly:
b) _________________ LED illuminates permanently:
c) - - - - - - - - - - - - - - LED is flashing very rapidly:
d) LED is off:
e) . . . . . . . . LED flashes rapidly:
f) . - . - . - . - . - . - . - . LED long flash/short flash:
LED
Note
• If an error has occured, try to start the charging process once again. If the LEDs are still flashing rapidly, please contact
your beyerdynamic dealer.
• The charging time is around 2 hours when the battery is completely empty.
• It is normal that the rechargeable batteries are heated up during the charging process.
• Clean the charging contacts with spirit or isopropyl alcohol from time to time.
Battery is charged
Battery is full
Error
No microphone unit is inserted into charging compartment
or has no contact
Forming mode
Charging in the forming mode
63