Audio Connection; Power Supply - Beyerdynamic MCW DIGITAL 200 Notice D'utilisation

1.2.3

Audio Connection

• Connect the XLR (10) or RCA (14) master output to the input of a mixing console/amplifier.
• Always route cables running to the unit where they will not be pinched or cut by heavy or sharp objects.
1.2.4

Power Supply

• Verify that the voltage rating of the unit matches that of the AC mains outlet you are to use. If you connect the unit to the
wrong voltage, you may seriously damage it.
• Always route cables running to the unit where they will not be pinched or cut by heavy or sharp objects.
• Connect the MCW-D 200 control unit to the mains (9). The internal power supply unit of the control unit can adjust auto-
matically between 90 V and 240 V at 50 - 60 Hz.
1.2.5 How to switch the Control Unit on/off
• Switch on the MCW-D 200 with the On/Off-switch (8) on the rear.
• During the first 15 seconds the MCW-D 200 control unit is started, the Power LED (1) is flashing green and an operation is not
yet possible.
• The Power LED (1) on the front will illuminate green, when the control unit is ready for operation.
• CAUTION: Always turn off the power when making input or output connections.
Rear
42
(8)
(14) (10)
Front
(1)
(9)