Arctic Air Smart Mode D'emploi page 11

from non-compliance of these
instructions.
• A replaceable water filter is designed
specifically for this product. If the
filter is broken or damaged, you can
buy a replacement part. For this
purpose, please contact our
customer service. You will find the
contact details on the last page of the
instruction manual.
• If the supplied cable does not work
correctly, please contact customer
service in order to avoid possible
dangers.
• When removing the cover for
changing of the filter, the ventilator
switches itself off and the water tank
begins to blink red until the cover is
put back on. This is a safety device.
TIPS:
• Place the Arctic Air™ Smart on a raised surface, such
as a table, desk, or sideboard.
• After refilling the water tank, let the filter absorb water
for at least 3 minutes before use. This ensures a faster
supply of cooled air.
• You will feel the effect greatest when sitting directly in
front of the Arctic Air™ Smart.
• The Arctic Air™ Smart will run for up to 8 hours on
high setting, 10 hours on medium & 12 hours on low
on a single charge. Even if the water tank is empty, the
filter remains wet and the Arctic Air™ Smart continues
to cool.
Note: Depending on room temperature and humidity.
Arctic Air™ Smart performs optimally at 50% humidity
(depending on the setting, the runtime may be
affected).
• The colder the water used, the cooler the effect. You
may therefore wish to use ice water or water with ice
cubes.
M18537_ArcticAirSMART_Manual_20190102_MM.indd 11
All manuals and user guides at all-guides.com
SETTING UP:
1. Place the Arctic Air™ Smart on a level surface.
NOTE: Use built-in cable guides along the
back to keep the cable away from the fan
(see ill. 1).
2. Open and fill the water tank (see ill. 2). We
recommend using a pitcher or measuring cup.
Do not carry the device to fill it. This could
allow water to leak. Open the water tank door
and fill the tank up to the MAX FILL line. Close
the water tank door when finished.
3. Use the filter drawer tab to pull out the filter
drawer and remove the filter. (See ill. 8)
Note: For best results, lightly pre-soak
under cold, running water. (See ill. 7) For
even greater cooling, place the damp filter
in the freezer until frozen. Place back in the
drawer when done.
4. Plug the narrower end of the cable into the
connector on the back of the Arctic Air™
Smart and plug the power adapter (GQ06-
050150-AG) into an electrical outlet. (See ill. 1)
NOTE: Use the built-in cable guides along the
back to keep the cable away from the fan.
USE:
1. To turn on the Arctic Air™ Smart, press the on/
off switch (see ill. 3).
2. Set the speed of the fan by pressing the switch.
You can choose between low, medium and high
modes. The indicator lights next to the switch
show you the speed at which the Arctic Air™
Smart is currently running (see ill. 4).
3. Use the regulator to adjust the airflow up or
down according to your preference (see ill. 5).
4. Choose the night light setting by pressing
the button (E) - the default setting is High
brightness.
• Standard: light on, high brightness
• 1st press: low brightness
• 2nd press: light off (see ill. 6)
5. To turn off the Arctic Air™ Smart, press the
button repeatedly until the fan turns off (one
further press of the button after low speed) and
the mode indicator lights no longer light up
(see ill. 3).
11
02.01.19 10:24