Important; Installation - AquaScape Aquaforce 4000-8000 Instructions Et Entretien

• Always operate the pump fully submerged. Failure to do
so will overheat the pump and cause it to fail, thus voiding
the warranty. DO NOT OPERATE DRY.
• Use only in fully assembled state, and be sure that both
the upper and lower cage screens are completely snapped
together. Failure to operate the pump without the filter
cage closed will allow large debris to enter the pump,
causing the pump to fail and voiding the warranty.
• DO NOT wear loose clothing that may become
entangled in the impeller or other moving parts.
• Keep clear of suction and discharge openings. DO NOT
insert fingers into pump with power connected.
• DO NOT pump hazardous materials or liquids, such as oil,
saltwater or organic solvents.
• DO NOT block or restrict discharge.
• Products returned must be cleaned, sanitized, or
decontaminated as necessary prior to shipment. This will
ensure that employees will not be exposed to health
Model Number
Item Number
Average Pond Size Recommendation
Maximum Flow Rate
Maximum Head Height
Motor Type
Wattage
Amperage
Power Cord Length
Pump Discharge Diameter
Multi-Hose Fitting Diameters
Warranty
*Wattage range depending on remote control flow setting

Installation

• The AquaForce Pump is designed to be submerged
directly in the pond. To maximize pond circulation, locate
the AquaForce pump as far as possible from the water
entering back into the water feature (Ex. 1).
• It is recommended that the pump NOT be positioned in
the deepest area of the pond. This will protect the fish by
4
hazards in handling said material. All applicable laws and
regulations shall apply.
AquaForce Pond Pump Specifications
• Input Voltage: 120V AC
• Input Frequency: 60 Hz
• Submersible pump
• For outdoor or indoor use
• Thermally protected
• This pump has been evaluated for use with freshwater only
• Input Amps and Wattage
AquaForce Adjustable Flow Pond Pump Specs
For ponds up to 16,000 US gallons
preventing the pond from completely draining in the case
of a leak in the plumbing or filter. Bricks or stones can be
used, if needed, to raise the pump up off the bottom of the
pond.
• The AquaForce includes a wide assortment of fittings.
Select the appropriate fitting(s) needed for your application
(Ex 2).
Multi-Hose Adapter
Ex. 1
US (866) 877-6637 |
☎
IMPORTANT: Aquascape, Inc. is not
responsible for losses, injury, or death
resulting from a failure to observe these safety
precautions, misuse or abuse of pumps or
equipment.
4000-8000
91104
7,794
28'
Asynchronous
500 - 660*
5.5
20'
1.5" MPT
1", 1.25", 1.5", 2"
3-Year Limited
CAN (866) 766-3426 | aquascapeinc.com
☎
Ex. 2