ENGLISH
FIRMWARE VERSION
Used to show the current version of the firmware.
Press the MODE button until the FIRMWARE is showing on the display.
The firmware of this unit can be upgraded using a special upgrade tool with Windows® software. (separately
available from Briteq). More information about this can be found in the user manual of the upgrade tool and /
or our website: www.briteq-lighting.com
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
STANDALONE WITH BUILT-IN CHASES:
Use this function when you want an instant show on only 1 projector.
Connect the projector to the mains and turn it on.
Select one of the following modes in the setup menu:
SOUND mode: if you want chase programs running to the rhythm of the beat. See the section "setup
menu" for more information on the settings.
STANDALONE mode: if you want chase programs running automatically but you want a certain
control over the selected chase. See the section "setup menu" for more information on the settings.
AUTO RUN mode: if you want chase programs running automatically. See the section "setup menu"
for more information on the settings.
STANDALONE MASTER/SLAVE WITH BUILT-IN CHASES:
Use this function when you want an instant show on only 1 projector.
By linking the units in master/slave connection, the first unit will control the other units to show a
synchronized automatic or sound activated light show.
Connect the projectors as shown in the drawing below
Setup of the master: exactly the same procedure as the "STANDALONE" setup.
Setup of the slaves: all slaves should be set to "SLAVE MODE", See the section "setup menu" for more
information on the settings.
ELECTRICAL INSTALLATION FOR TWO OR MORE UNITS IN DMX-MODE:
Use this function when you want to control the projectors by any DMX controller.
Connect the projectors as shown in the drawing below.
BRITEQ
®
11/109
OPERATION MANUAL
BEAMMATRIX5x5-RGBW