Briteq BEAMMATRIX5x5-RGBW Mode D'emploi page 11

ENGLISH
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired curve:
 Once you have the desired curve, press the ENTER button to save it.
LAMP BEHAVIOR
Used to select the reaction time of the projector.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 LED
 HALOGEN
 Once the correct option shows on the display, press the ENTER button to save it.
LOCKING MODE
Used to lock the setup menu against unwanted altering of the settings.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 OFF
The setup menu can be used at any time.
 ON
After a short time the setup menu locks automatically, the display shows " LOCKED ***** ".
Unlock the display by pressing the buttons in this order: UP, DOWN, UP, DOWN, ENTER.
 Once the correct option shows on the display, press the ENTER button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 BLACKOUT
 FREEZE:
 Once the correct option shows on the display, press the ENTER button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
DEFAULT SETTINGS
This is your emergency exit if you really messed up the settings: just return to factory settings.
Also 2 user settings can be saved/loaded.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired settings:
 FACTORY
 USER1
 USER2
 Press the ENTER button:
 FACTORY was selected: the display shows "LOAD"
 Press the ENTER button: the display shows "CONFIRM?"
 Use DOWN and UP buttons to select YES / NO
 Press the ENTER button to confirm.
 USER1 / USER2 was selected: the display shows "ACTION?"
 Use DOWN and UP buttons to select LOAD / SAVE
BRITEQ
®
The projector follows the instructions instantly, no delay.
The projector imitates the behavior of a halogen lamp (slower reaction time).
output turns black while no DMX is detected.
output based on the last valid DMX-signal is kept on the projector.
9/109
OPERATION MANUAL
BEAMMATRIX5x5-RGBW