BYK haze-gard plus Mode D'emploi page 10

Setting Up
All manuals and user guides at all-guides.com
Always switch off the unit before
plugging in or unplugging the
various connectors (foot switch,
printer cable and power cord).
Make sure the voltage setting is
correct. Otherwise the instrument
will not operate properly or
safely.
possible damage sustained during
shipment (visual inspection).
first time, make sure all compo-
nents have been delivered (for the
package contents see Chapter 13,
Ordering Guide).
the instrument, and if necessary
change it to the right setting as
follows: Use an appropriate tool
(No. 2 screwdriver) to remove the
fuse insert below the power-cord
receptacle, and plug the insert
back in so that the mark on the
power-switch housing coincides
with the required voltage range.
RS-232
foot-
switch
T 1,6A 250V (115V)
T 1,0A 250V (230V)
MADE IN GERMANY
off. Plug the enclosed power cord
into the unit and into a grounded
power outlet.
and the printer or PC connection
cable into the appropriate recepta-
cles.
!