Removing And Installing The Battery Pack - Fujitsu STYLISTIC LT C-500 Guide De L'utilisateur

Battery Pack Charge
Level Reached
90%
100%
* Actual charge time will be determined by the applications in use.
Also note the following with respect to charging the battery pack:
• You can use the system, suspend system operation, or shut down and turn off the
system without interrupting the charging process; however, using the system
while the battery pack is charging will cause the battery pack to charge at a slower
rate, as noted in Table 2-3.
• As noted in the procedure above, the system will not begin charging the battery
pack if the battery pack charge level is 90% or higher when the system is initially
connected to external DC power. (This prevents the battery pack from being
overcharged.)
• The Stylistic LT C-500 battery pack uses Lithium ion battery cells which have no
"memory effect." You do not need to discharge the battery pack before you begin
charging.

Removing and Installing the Battery Pack

The battery pack can be removed from the pen tablet and swapped with a charged
battery pack. The battery pack can then be charged in an external charger if one is
available. To remove the battery pack from the pen tablet:
1. Choose one of the following:
• If a charged battery pack is available, you can suspend system operation. A
built-in "bridge" battery will maintain the system in Suspend-to-RAM mode
for about 5 minutes while the battery pack is removed; this allows time for
replacement with a charged battery pack.
• If a charged battery pack is not available, save your work and close all
running programs, then shut down the system or Save-to-Disk.
• Plug in an external AC/DC power source.
26 Using the Stylistic LT C-500 Pen Tablet
All manuals and user guides at all-guides.com
Table 2-3 Battery Pack Charging Time
Approximate Charge Time
(tablet not in use)
3 hours
4 hours
Approximate Charge Time
(tablet in use)
6 hours*
8 hours*
2