Resuming System Operation - Fujitsu STYLISTIC LT C-500 Guide De L'utilisateur

Note: If you will not be using the system for an extended period of time, shut down the
system rather than using Suspend-to-RAM mode.
• If the battery pack charge drops to a Low-Battery Warning level while the system
is running, the system will beep periodically. If this occurs, suspend system
operation, shut down the system, or attach an external power source, such as the
AC adapter, to the pen tablet.
• If the battery charge drops to a Critically Low level while the system is running,
the system is forced into a pre-selected mode (Suspend-to-RAM or Save-to-Disk).
If this occurs, you must either install a charged battery pack, or connect an
appropriate external power source such as the AC adapter before you can resume
system operation. (If the battery charge drops to a Critically Low level while the
system is in Suspend-to-RAM mode, the system stays in Suspend-to-RAM mode
until power is restored or totally dissipated.)
• Suspending system operation interrupts data communications; therefore, some
programs may block the system from suspending to prevent an interruption.
• The suspend action of the Suspend/Resume button may be disabled to prevent
accidental interruption. If this is the case, pressing the Suspend/Resume button
will not suspend system operation as described here. (In this case, suspend mode
can only be achieved using the system software). Contact your local help desk or
reseller if your system configuration is not suitable.
• If your system is equipped with a PC Card that allows you to connect to a wired
or wireless network, you may be logged off the network after a period of
inactivity while system operation is suspended. Contact your network
administrator or local help desk for details on log-off parameters for your
network.

Resuming System Operation

To resume system operation, (from either Suspend-to-RAM or Save-to-Disk modes),
press the Suspend/Resume button.
• From Suspend-to-RAM mode
Status lights indicate that the system state is changing. It may take up to a minute
before the system returns to the On state and system operation resumes. Note that
the display turns on shortly before the pen becomes active due to the power-up
sequences observed by the system.
• From Save-to-Disk mode
Active data is read from the hard disk drive, and the system returns to the On
18 Using the Stylistic LT C-500 Pen Tablet
All manuals and user guides at all-guides.com
2