Pir Mo On Sensors - Tiiwee X3 Mode D'emploi

Sideways installa on and installa on with double-sided tape: Peel off the
●
protec ve foil from one side of the tape and s ck the tape onto the sensor.
Then, peel off the other part of the protec ve foil and s ck the sensor onto
the door or doorpost.
Installa on with screws: Using a small screwdriver or the p of a small knife,
●
remove the cover from the sensor by li ing the cover. Then, posi on the
sensor at the desired posi on. Now, reposi on the cover carefully on the
sensor, making sure not to damage the clips.
Test your door sensor
1. A er the installa on, open the window or door.
2. The red indicator light on the front of the sensor will flash once.
3. The sensor is now correctly setup.

PIR mo on sensors

Product Overview and ac va on
Indicator light
Detector window On/Off switch
Open the back panel to insert the ba eries. Please respect the correct polarity.
Now, close the back panel again. Slide the ball joint in place un l it locks in
place. Then, a ach the wall mount on the ball joint. Your PIR sensor is now
ready to be installed on the mount.
Micro USB port Wall mount plate
14
General installa on guidelines
Avoid posi ons close to a window, air condi oners, fluorescent lights, heaters,
refrigerators, stoves, and direct sunlight and other places where the
temperature would change rapidly, and air flow is high. If there are two
detectors in the same detec ng range, please adjust the posi on to avoid
interference and false alarms.
A ach the detector to the bracket, and change the detec ng angle and distance
by adjus ng the installa on height and the bracket. It is advised to install the
device at a height of approximately 2 meters.
IMPORTANT: The Infrared detector is sensi ve to a human's horizontal movement.
The detector is less suscep ble to ver cal movements. Therefore, it is advised
to aim the device at a 90 degrees' angle to a person's walking direc on.
How to mount a PIR mo on sensor
Unlike magne c door and window sensors, PIR mo on sensors recognize heat
differences. Some mes heat differences are unno ceable. Our PIR mo on
sensors feature advanced algorithms that help to detect the difference
between a human being and environmental heat changes. However, it is
essen al to carefully select the right posi on of PIR mo on sensors for it to
properly func on. Here are a few recommenda ons:
Therefore, we recommend installing the mo on detector in a corner that is void
from any of those factors men oned above, and where the sensor looks into
the room you want to guard.
Test
1. A er the installa on, turn the switch to ON. Now, walk or move in front of
the PIR sensor at a distance between 3 and 6 meters.
2. The Indicator light should light up once. Note the 5 seconds delay between 2
signals. The delay is normal and inten onal to save ba ery power.
3. If needed, adjust the detector angle to get the desired detec on range.
15