Installing Your Tiiwee Alarm System In Four Simple Steps - Tiiwee X3 Mode D'emploi

Installing Your Tiiwee Alarm System in 4 simple steps
1. Unpack:
Unpack all kit components and lay them in front of you on the table.
2.Remove Ba ery Protec on:
X3 Siren: Open the back panel from the
X3 Siren and remove the white ba ery
protec on.
Window sensors: Pull out the white ba ery protec on at the back of the sensor.
4
Mo on detector (if included): Insert ba eries (included with the product).
Please assure correct polarity.
3. Familiarize Yourself with Your System:
a. Arrange the window sensors such that the magnet is on the right-hand side
of each sensor. The li le triangles on the middle of the sides of the sensor
and the magnet cannot be more than 8 mm apart. Posi on them so that
they are facing each other.
Posi on the mo on detector with the detec on window facing away from
you (to avoid that it detects anything)
b. Slide the Home/Away bu on into the "Home" posi on (
Ac va on-bu on ( ) . You will hear one beep and the zone LEDs will
flash once.
c. Cover the siren outlet of the X3 with you hand in order to reduce the siren
sound during the func onal test.
d. Now move the magnet away from the
first sensor. You hear the siren sound
and the red light on the sensor will light
up. Stop the siren alarm by entering the
preset 4-digit code 1-2-3-4 on the
keypad. The siren will stop and you will
hear 2 beeps and the LEDs will flash twice.
Repeat this procedure for all other window sensors by, one by one,
removing all magnets from their sensors.
e. Mo on detector (PIR kits only): Wave your hand approximately 50 cen meters
in front of the mo on detector. You hear the siren sound and the red light
on the sensor will light up. Stop the siren alarm by entering the preset
4-digit code 1-2-3-4 on the keypad.
beeps and the LEDs will flash twice.
) and press the
The siren will stop and you will hear 2
5