System Overview - Tiiwee X3 Mode D'emploi

Features of the X3 alarm system
"Home" and "Away" alarm mode
●
3 sounds: mild doorbell, loud doorbell and a very loud 120dB siren
●
4 zones: 3 "normal"-alarm zones and one "Welcome"-zone.
●
Maximaal 10 sensors per zone
●
Alarmed zone indica on
●
Passcode protected
●
Indicator light for ac vated status
●
Power supply by 3 x 1,5 AA ba eries (included) or 220V power adapter (not
●
included)
Principle of the X3 alarm system
The Tiiwee X3 Home Alarm System is designed primarily to create a loud siren
alarm sound when a burglar is trying to enter your home. The basis of the
system is the X3 Siren. Place the siren in your home at a posi on where
burglars are most likely to enter.
No remote control needed
The X3 alarm system does not require a remote control. All opera ons are carried
out on the X3 alarm unit itself. The X3 alarm unit is always on - regardless of if
in deac vated or in ac vated mode.
2 zone-types
The X3 features 4 zones - 3 "Normal"-alarm zones and 1 "Welcome"-zone. You
can connect up to 10 sensors per each zone.
1. "Normal"-zones - sensors in this zone will trigger a loud 120 dB siren when
the X3 is ac vated.
2. "Welcome"-zone - sensor connected in this zone will trigger a "DingDong"
-sound in deac vated mode and a loud siren alarm in ac vated mode. The
"DingDong"-sound can be adjusted to a low or a high volume.
2 modes
The X3 alarm can be used in 2 modes:
1. "Home"-mode: You are at home and want the system to be guarding your
home immediately when you ac vate it. If a sensor is triggered, the siren
will sound immediately without any delay.
2
2. "Away""-mode: You leave your home and you want the system to respect a
20 second delay before ac va ng itself. This allows you to press the
Ac va on-bu on and leave the house before the system starts guarding
your home. Upon your return, the system will delay its siren 15 seconds
which allows you to deac vate the system with your 4-digit code.
Please refer to the below table for an overview.
Zone # Amount Zone type
of sensors
Zone 1 10 "Normal"
Zone 2 10 "Normal"
Zone 3 10 "Normal"
Zone 4 10 "Welcome"
In ac vated mode all sensors will trigger a loud siren alarm.

System overview

Siren
Mul func onal
keypad
Home/ Away bu on
Ac va on-bu on
The system is ready for use. Your system is preconfigured, and the window
sensors are connected to zone 1 on the X3 alarm unit. If a PIR mo on sensor is
included, it is connected to zone 2. We advise to read this user manual carefully
and to familiarize yourself with its basic opera ng principle and ways to fine-tune
the alarm system to your exact needs.
Deac vated Ac vated in Ac vatedin
"Away" mode "Home" mode
- siren siren
- siren siren
- siren siren
"DingDong"-sound siren siren
Zone indicator
"DingDong"-sound
volume bu on
DC 5V power inlet
3