PRO-POINT 8561193 Manuel D'utilisateur page 24

8561193
23 Gauge Pin Nailer
V1.0
4. Use a pressure regulator on the compressor, with
an operating pressure of 0 to 125 psi. A pressure
regulator is required to control the operating
pressure of the tool between 60 psi and 100 psi.
CAUTION: The air compressor must be able to maintain
a minimum of 60 psi when the tool is being used. An
inadequate air supply can cause a loss of power and
inconsistent driving.
WARNING: Do not connect with an air compressor which
can potentially exceed 200 psi. As tool may burst,
possibly causing injury.
STORAGE
When not in use for an extended period, apply a thin coat
of lubricant to the steel parts to avoid rust. Remove the
lubricant before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the
appropriate facility.
24
For technical questions call 1-800-665-8685