PRO-POINT 8561193 Manuel D'utilisateur page 22

8561193
2.
3.
23 Gauge Pin Nailer
Turn the tool so the air
inlet is facing up. Place
2-3 drops of pneumatic
fastening tool oil into air
inlet. Do not use
detergent oils, oil
additives, or air-tool oils
as these lubricants will
cause accelerated wear
to the seals and bumpers
in the tool, resulting in poor
tool performance
and frequent
tool maintenance.
After adding oil,
connect the tool to
the air source, run tool
briefly. Wipe off any
excess oil from the
cap exhaust.
V1.0
•
CAUTION: The work surface can become damaged by
excessive lubrication. Proper lubrication is the owner's
responsibility. Failure to lubricate the tool properly will
dramatically shorten the life of the tool and void
your warranty.
CAUTION: Lubricate tool only with specified lubricants.
CLEANING
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and maybe damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
22 For technical questions call 1·800-665·8685