Important; Troubleshooting Guide - Topdon Volcano2000PRO+ Mode D'emploi

Portable lithium-ion jump starter for 12v cars & trucks
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35

Important

The battery jump procedure is only for use on vehicles with 12 volt batteries.
Use only the smart battery clamps supplied with this product.
Only jump start the vehicle when capacity is at least 50%.
Better not get the two battery clamps contacted together.
If the engine does not start, disconnect this product from the vehicle battery, and wait for
at least 20 seconds before reconnecting. Maximum three attempts are allowed in 2 minutes.
Once the vehicle engine is successfully started, disconnect the clamps within
30 seconds.
DO NOT use this product if any cable, clamp or cord is damaged.
DO NOT put the product under the direct sunlight or hot areas.
DO NOT disassemble the equipment.
DO NOT use chemicals or detergents to clean the product.
DO NOT place the products in high temperature environment for a long time.
Check the charge level of the device every four months, and charge the device if needed.
14

Troubleshooting Guide

Q: How to turn off this product?
A: This product will automatically power off while not being used.
Q: How long time does it need to get fully charged?
A: Via the Type-C USB input, the device will need approximately four to five hours to get
fully charged.
Q: How many times can this product jump start a vehicle battery on a single charge?
A: About 25 times.
15

Publicité

Table des Matières
loading

Table des Matières