1.Connect the smart battery clamp CP020 to the jump starter, default mode is jump start
1.
mode, the [OK] LED will illuminate indicating ready to use, and [Fault] indicating jump
starter battery level too low, needs to be charged;
2.
Connect the red clamp to the positive terminal (POS, P, +) of the battery; and connect the
black clamp to the negative terminal (NEG, N,-) of the battery;
Start the vehicle;
3.
4.
When your vehicle is started, disconnect the clamps from the vehicle battery.
Test your vehicle battery on App
Press switch mode button on battery clamp CP020 to switch to battery test mode, blue
1.
LED flashes, indicates CP020 in bluethooth pairing phase. Connect phone with CP020 fol-
lowing the instruction on BT Mobile App. When connection established, blue LED is solid.
Conduct battery tests following the instructions on App.
2.
10
Attention:
Digital Display
Under voltage, V2000 Pro+ battery voltage is under 10V,
UV; showing -- -- --
please charge the jump starter; or when vehicle battery
is under 8V;
Current back flow, V2000 Pro+ battery level too low,
OV; showing -- -- --
please charge the jump starter;
Current back flow, V2000 Pro+ battery level too low,
CB; showing -- -- --
please charge the jump starter;
Over temperature, turn off V2000 Pro+ wait for it cool-
OT; showing -- -- --
ing down;
Short circuit, clear battery posts and clamps, check
SC; showing -- -- --
the connection in between;
Exceed Connection time/overload, clear battery posts
No Icon; showing -- -- --
and clamps, check the connection in between.
Tool Status
11